Author Topic: TE 0304 - VGA-interface SDA and SCL signals  (Read 4442 times)

JS

  • Active Member
  • *
  • Posts: 32
  • FPGA-Design & Signal Processing
TE 0304 - VGA-interface SDA and SCL signals
« on: January 08, 2013, 06:34:15 AM »
In the docu of the TE 0304, I found, that both signal are announced:

VGA_SCL   IO_L22P_3   P3    VGA_SDA   IO_L22N_3   P4    for TE0300

VGA_SCL   V3_IO_12    T2     VGA_SDA   V3_IO_13    T1    for TE0630

... while in the SCH, they seem to be wired to 3,3 over a 2,2k Resistor.

Is this a mismatch?

I did not try so far, but if this is available I would like to try to make use of it.


JS

  • Active Member
  • *
  • Posts: 32
  • FPGA-Design & Signal Processing
Re: TE 0304 - VGA-interface SDA and SCL signals
« Reply #1 on: January 08, 2013, 06:56:52 AM »
I think, I got it - it is virtually wired in sheet 2 - so it seems ok.
« Last Edit: January 08, 2013, 07:00:44 AM by engineer »