Trenz Electronic Products > Trenz Electronic FPGA Modules

TE0725 3.3v power supply pins.

(1/1)

Trenz0691:
Hi
Should be pin 5 & 46 of both J1 and J2 powered with external 3.3v supply  in order to power up the module TE0725?
Is it also possible to power up the module by supplying only 3.3v to pin 5 of JB1, JTAG/uart connector? 
Thanks

Waldi3141:
Hi,
supplying 3,3V to one of those Pins is normally enough to power up the board.
Yes 3.3V can also be supplied over JB1 (mind the power rating of the supply, TE0790 is not suitable here for delivering power)

good luck!

Trenz0691:
Thanks @Waldi3141

Navigation

[0] Message Index