Author Topic: TE0820 Custom Carrier DisplayPort Implementation  (Read 87 times)

mer

  • Active Member
  • *
  • Posts: 5
TE0820 Custom Carrier DisplayPort Implementation
« on: September 23, 2022, 12:24:32 AM »
Using TEBF0808 as a reference I noticed that the the DPAUX signals (OE, HPD, AUX_IN, AUX_OUT) are routed to one of the CPLDs. I'm assuming this is because these signals are 3.3V and the CPLD is essentially serving as a level shifter to 1.8V since all MIO are 1.8V on the carrier. Would it be appropriate to use a SN74A type level shifter instead? Should I remove the resistors (R40, R41) from HPD? Any other considerations? Thank you.

Vitali

  • Active Member
  • *
  • Posts: 4
Re: TE0820 Custom Carrier DisplayPort Implementation
« Reply #1 on: September 23, 2022, 09:00:06 AM »
Hi,
TEBF0808 is the carrier board for TE0803/TE0807/TE0808. If you are using the TE0820 micromodule, the MIO Bank501 is connected to 3.3V and you don't need to use a level translator. The HPD signal should be pulled down by at least 100k and you can remove the resistors R40, R41 in your project.

mer

  • Active Member
  • *
  • Posts: 5
Re: TE0820 Custom Carrier DisplayPort Implementation
« Reply #2 on: September 23, 2022, 05:09:58 PM »
Oops, messed up the title. Making a custom carrier for TE0808 so MIO is all 1.8V.

Vitali

  • Active Member
  • *
  • Posts: 4
Re: TE0820 Custom Carrier DisplayPort Implementation
« Reply #3 on: September 26, 2022, 03:36:56 PM »
If you don't like using a CPLD, you can use a level translator as an alternative.