« previous next »
Pages: [1]

Author Topic: Gigabee and Carrier Board power consumption  (Read 8434 times)

RDT2

  • Active Member
  • *
  • Posts: 3
Gigabee and Carrier Board power consumption
« on: October 06, 2011, 07:09:53 PM »
I'm trying to spec out the amount of batteries I will need to power the Gigabee and it's carrier board. I was hoping you could provide typical current draws for a medium sized/medium speed fpga configuration for your system similar to what is provided on the Digilent devices.

See Page 9 of http://digilentinc.com/Data/Products/ATLYS/Atlys_rm.pdf
See Page 8 of http://digilentinc.com/Data/Products/NEXYS3/Nexys3_rm.pdf

Logged

Thorsten Trenz

  • Administrator
  • Full Member
  • *****
  • Posts: 156
    • Trenz Electronic GmbH
Re: Gigabee and Carrier Board power consumption
« Reply #1 on: October 07, 2011, 02:10:08 PM »
 Hi,
 we did a few measurements. Setup was GigaBee on TE0603-02 baseboard, connected to Gigabit Ethernet. 5V Powersupply connected to the baseboard.

FPGA Type | Unconfigured |Webserver Referencedesign
LX45 0.15A 0.6A
LX100 0.17A 0.5A
LX1500.2A0.5A


best regards
Thorsten Trenz
« Last Edit: October 07, 2011, 02:26:29 PM by Thorsten Trenz »
Logged
Pages: [1]
« previous next »