Gigabee and Carrier Board power consumption

[RDT2]

I'm trying to spec out the amount of batteries I will need to power the Gigabee and it's carrier board. I was hoping you could provide typical current draws for a medium sized/medium speed fpga configuration for your system similar to what is provided on the Digilent devices.

See Page 9 of http://digilentinc.com/Data/Products/ATLYS/Atlys_rm.pdf
See Page 8 of http://digilentinc.com/Data/Products/NEXYS3/Nexys3_rm.pdf

[Thorsten Trenz]

 Hi,
we did a few measurements. Setup was GigaBee on TE0603-02 baseboard, connected to Gigabit Ethernet. 5V Powersupply connected to the baseboard.

FPGA Type |	Unconfigured |	Webserver Referencedesign
LX45	0.15A	0.6A
LX100	0.17A	0.5A
LX150	0.2A	0.5A

best regards
Thorsten Trenz