TE0820 -03 and -04 MODE Pin

[lalit]

We are using TE0820-03 and will be using -04 soon.
I was looking at TRM for both configurations and MODE pin setting Table 2 in -04 is reverse of -03.
Has Trenz actually changed this?

Second question, is it actually fine to float the MODE pin if booting from QSPI?

Thanks.

[JH]

Hi,
no it was only a mistake in the documentation, see document history:
https://wiki.trenz-electronic.de/display/PD/TE0820+TRM#TE0820TRM-DocumentChangeHistory


We have weak pullup enabled (booting from flash), so floating is possible. But I would not recommend to keep boot mode not controllable. With every new Vivadoversion you get more and more trouble to program QSPI flash, when you has fix boot mode QSPI, so it's more save to have it controllable. --> Add Pullup also on your carrier and Jumper which can set it to gnd.

Here is also some general information about our 4x5 series:
https://wiki.trenz-electronic.de/display/PD/4+x+5+SoM+LSHM+B2B+Connectors

br
John