NIOS II - Flasing the elf file

[sjoshi]

Hello,

I am playing with my new CYC1000 board and have come across my first problem (That Google could not help me solve)

I could test a simple counter to flash the LEDs and it worked like a charm. Next, I am following the steps to implement a NIOS core to send a "Hello World" message over the JTAG UART. Everything goes well till the compilation of the C code. I can flash the fpga with the image as well. However, when I try to flash the elf file, I get the following error:

Using cable "Arrow-USB-Blaster [USB0]", device 1, instance 0x00
Pausing target processor: not responding.
Resetting and trying again: FAILED
Leaving target processor paused

I have tried it from the NIOS SDT as well as from the command line console. I did not find any unassigned pins (only clk needed to be assigned)

The clock is running at a basic 12MHz.

Is this a known problem or can anyone guide me in the right direction?

Regards,
Shailesh

[sjoshi]

Hello again,

I am glad to report that I was able to find the fault and rectify it.

It turns out that my clock of 12MHz was indeed too slow compared to the JTAG clock. There was a warning about this when setting up the IP but I did not give it much of a thought back then.

I am guessing there are two ways to solve this problem and i might have taken the more complicated way.

The easier method will be to add a PLL to clock the NIOS at 50MHz or more.

My solution includes finding the current JTAG clock using the command:
jtagconfig.exe --getparam 1 JtagClock

run under the console. Returns 20M.

Setting this parameter to 4M using the command
jtagconfig.exe --setparam 1 JtagClock 4M

seems to have solved the problem.

[antchairman]

This clock is delivered as LVCMOS on the CLK125 output pin. The voltage level, in my configuration, is 1.8V.  I would much like avoid having to convert this to differential in order to provide the B244_CLK0_P/N pins on my TE0803 with clock signals. There are two different approaches to this problem that come to mind.

mapquest directions