Author Topic: Image sizes  (Read 3641 times)


  • Active Member
  • *
  • Posts: 4
Image sizes
« on: March 07, 2019, 08:05:15 AM »

I am quite new to the CYC1000 and Cyclone 10LP and am wondering how large programs the flash can hold.
As I understand the boot process, the flash holds both the fpga image and the software for NIOS II.
Can anyone provide a rough estimate of the possible size of a NIOS sw that can be stored?


  • Active Member
  • *
  • Posts: 1
Re: Image sizes
« Reply #1 on: August 21, 2023, 10:36:41 AM »
On the TEI0003-01 board, I measured the amount of current that was drawn. I supplied power to the board using the VIN pin, which outputs 5 volts.
Without an FPGA design: around 60 milliampere-seconds; with our reference design: approximately 100 milliampere-seconds.