Author Topic: Quartus 18.1 - Can't Start JTAGSERVER  (Read 148 times)

jwest6

  • Active Member
  • *
  • Posts: 2
Quartus 18.1 - Can't Start JTAGSERVER
« on: February 07, 2019, 02:10:17 PM »
Hello,

I'm trying to get the JTAG server to connect with the programmer on the CYC1000 - and am getting
the following:

Arrow USB Programmer2 Diagnostic Program V1.1

Reading version info.
- Operating system version number is 10.0.17763.
- Quartus version is 18.1.0.625.

Searching programmer hardware.
- Arrow USB Programmer2 AR2E3I3D found.
- Successful.

Reading registry entries for programmer DLL.
- Successful. TCK frequency is 20.000.000 Hz.

Searching programmer DLL.
- Successful. Programmer DLL installed properly.

Checking Altera JTAG server service.
- JTAG Server is installed but not running.
- Error. Wait timed out after sending start request.

Reading registry entries for FTDI driver configuration settings.
- Successful. FTDI driver configuration settings are OK.

Total errors: 1
Hit any key to exit program.

Thanks in advance for any help/hints.

Regards,
John W.

jwest6

  • Active Member
  • *
  • Posts: 2
Re: Quartus 18.1 - Can't Start JTAGSERVER
« Reply #1 on: February 07, 2019, 02:41:02 PM »
Hello Again,

Guess all is well - I had another USB Blaster plugged in - not sure if that was interfering or what exactly - but seems to be OK now:

F:\Users\John\Downloads>Arrow_USB_Programmer2_diagnostic.exe

Arrow USB Programmer2 Diagnostic Program V1.1

Reading version info.
- Operating system version number is 10.0.17763.
- Quartus version is 18.1.0.625.

Searching programmer hardware.
- Arrow USB Programmer2 AR2E3I3D found.
- Successful.

Reading registry entries for programmer DLL.
- Successful. TCK frequency is 20.000.000 Hz.

Searching programmer DLL.
- Successful. Programmer DLL installed properly.

Checking Altera JTAG server service.
- Service has been stopped successfully.
- Service has been started successfully.

Reading registry entries for FTDI driver configuration settings.
- Successful. FTDI driver configuration settings are OK.

Total errors: 0
Hit any key to exit program.

Regards,
John W.